Rockwell Automation 6176M-xxxx Standard Industrial Monitors User Manual - Manual (Page 18)

18 Rockwell Automation Publication 6176M-UM001D-EN-P - December 2012
Chapter 2 Installation
Figure 2 - Rack Mounting a 1950M Monitor
VESA Mounting
Use the optional bench/tabletop adapter for monitors, catalog number
6189V-MBA, to mount your VESA monitor on a bench or tabletop.
VESA Mounting Guidelines
Observe these guidelines when installing the VESA monitor on an arm:
• The mounting surface and the mounting arm must be strong enough to
support both the monitor and the mounting hardware.
• The interface between the arm and the monitor must meet VESA
FPMPMI 100 mm (3.94 in.) standards.
• The mounting location must provide adequate clearance for positioning
and moving the adjustable unit and for routing cables.
ATTENTION: The mounting rails that run vertically along the inside edges of
the front opening of an EIA-rack cabinet are either wide or universal:
• Wide rails have holes spaced 12.7 mm (0.5 in.) and 31.8 mm (1.25 in.) on
centers, in a repeating pattern. Wide rails are prevalent in Europe.
• Universal rails have holes spaced 12.7 mm (0.5 in.), 15.9 mm (0.625 in.), and
31.8 mm (1.25 in.) on centers, in a repeating pattern. The universal rails have a
hole pattern that contains the wide pattern but provides an additional hole at
the midpoint of the pattern. Universal rails are prevalent in the United States.
B
D
D
B
D
D
C
A