Rockwell Automation 6176M-xxxx Standard Industrial Monitors User Manual - Manual (Page 19)

Rockwell Automation Publication 6176M-UM001D-EN-P - December 2012 19
Installation Chapter 2
Mount the Monitor on a Bench or Tabletop
Follow these directions to mount the VESA monitor to a bench or tabletop.
1. Mount the arm to the bench or tabletop by using screws, bolts, or clamps
so the monitor cannot tip.
2. Align the VESA mounting holes in the back of the monitor with the holes
in the arm bracket.
3. Insert the four supplied VESA mounting screws through the arm brackets
and into the monitor.
4. Tighten the screws to secure the VESA monitor to the arm.
Monitor Connections Use the connectors on the rear of the monitor to connect the following:
• Analog video source (HD-15 VGA connector)
• Digital video source (DVI connector)
• Serial port on a computer for the optional touchscreen interface
• USB port on a computer for the optional touchscreen interface
• USB hub device ports for connecting peripheral devices
• Power (DC input connector must be used with supplied AC power adapter)
Monitor Mounting Holes (4)
Install Arm Install Monitor to Arm
No. Connector No. Connector
1 DVI-D video input 5 DC power input (AC adapter)
2 HD-15 video input 6 USB Type A connection to peripheral devices (2)
3 USB Type B connection to computer 7 M5 ground screw
4 RS-232 input (optional)
1 2 3 4 6 5 7
Back of Monitor