Rockwell Automation 2711C-xxxx PanelView Component HMI Terminals - Manual (Page 42)

42 Publication 2711C-UM001I-EN-P - July 2014
Chapter 2 Configuration Mode
If DHCP is enabled for the Ethernet port, the current fields show the IP
addresses assigned by the network. You can assign IP addresses manually by
disabling DHCP and entering addresses in the static fields.
Follow these steps to set a static IP address for the Ethernet port of the connected
terminal using the PanelView Explorer Startup window.
1. Go to the PanelView Explorer Startup window.
2. Click the Terminal Settings link.
3. Click the Communication tab.
4. Uncheck the Use DHCP? option to manually enter IP addresses.
5. Enter an IP address in the Static IP address field.
6. Enter the default mask in the Static Subnet mask field.
7. Enter the default gateway in the Static Default gateway field.
8. Click Apply or click Cancel to restore the current IP address.