Rockwell Automation 2711C-xxxx PanelView Component HMI Terminals - Manual (Page 31)

Publication 2711C-UM001I-EN-P - July 2014 31
Configuration Mode Chapter 2
The repeat rate is the speed at which a character repeats per second when you
hold down a key. The repeat delay is the amount of time, in milliseconds, that
elapses before a character begins to repeat when you hold down a key.
Follow these steps to change the repeat settings for keys.
1. Go to the PanelView Explorer Startup window.
2. Click the Terminal Settings link.
3. Click the Display/Input tab.
4. Check Enable key repeat to enable repeat settings for keys.
5. Drag the slider under Key Repeat Rate to adjust the speed at which a
character repeats when a key is held down.
6. Drag the slider under Key Repeat Delay to set the amount of time that
elapses before a character begins to repeat when the key is held down.
7. Click Apply or click Cancel to restore the current settings.
To disable key repeat settings, uncheck Enable key repeat.
Calibrate the Touch Screen
Over time you may notice that the objects and images on the display screen don’t
seem to fit the display area as well as they once did. This is normal with a touch
screen and can be easily fixed.