Rockwell Automation 2085 Micro800 Discrete and Analog Expansion I/O Modules - Manual (Page 51)

Rockwell Automation Publication 2080-UM003A-EN-E - March 2013 43
Configure Your Expansion I/O Module Chapter 5
After deleting 2085-IF4 from slot 2, the project graphic should look
like this:
3. On the empty slot (slot 2), right-click and select 2085-OW16.
4. Next, replace 2085-OB16 in slot 3 with a 2085-IQ32T device.
Right-click 2085-OB16 in slot 3, and choose 2085-IQ32T.
The project graphic and Expansion Modules list should look like these
after the modules are replaced:
2085-OW16
2085-IQ32T
TIP You can also delete and replace an expansion I/O through the Expansion
Modules list. To replace, right-click the expansion I/O module you would
like to replace, then select the Expansion I/O module you would like to
replace it with, from the list that appears. To delete the Expansion I/O,
choose Delete.