Rockwell Automation 9323-PA2E APS SLC 500 Import/Export Utility User Manual - Manual (Page 60)

Creating an ASCII Archive File
5-25
Table 5.U
Control Bits for Control Files Defined by the Word CTL
Bit Address Bit Name Bit Number
R6:0/EN Enable 15
R6:0/EU Enable Unload -or- Queued
➀
14
R6:0/DN Done -or- Asynchronous Done
➀
13
R6:0/EM Empty -or- Synchronous Done
➀
12
R6:0/ER Error 11
R6:0/UL Unload 10
R6:0/IN Inhibit -or- Running
➀
09
R6:0/FD Found 08
➀
When CTL is used with an ASCII instruction.
Entering the Project Name and Program File List
The project name format consists of the keyword “PROJECT”, project name,
program file number and program filename. For example:
PROJECT “AB” 2 “POWERUP”
Keyword
Project Name Program File Number
Program Filename
Use up to eight alphanumeric, underscore, or IBM–extended characters, in any
combination, to specify the project name. If the project name does not match the
filename of the archive file, or if the project name is left blank, the import utility
uses the name of the archive file.
The list of program file numbers and names, if included, follows the project name.
You must specify the file number first, then the filename.
The file number is an immediate integer value (2–15 for MicroLogix 1000
controllers; 2–255 for all other controllers and processors). You do not have to
specify the program file numbers in order, for example: 2 “AB” 5 “A” 3 “B”.
You specify the program filename like the project name. You may use up to ten
characters.