Rockwell Automation 2706-LV2S_LV4S DL40 PLUS SLAVE USER MANUAL - Manual (Page 9)

Publication 2706-6.3
P-2 Preface
Intended Audience
No specialized knowledge is required to configure and install the
DL40 slave display. However, we assume the following:
• The person responsible for equipment connections is familiar
with standard wiring practices and electrical codes in your area.
• Communication cabling is done by a person having an
understanding of basic communications terminology and cabling.
• Panel cutouts are made using the same methods and safety
practices followed for other panel mounted equipment.
Conventions Used
The following conventions are used in this manual.
• The up caret, ^, may be used in place of [Ctrl] (Control key)
where space is limited.
• Values in a hexadecimal format have the suffix “hex”. For
example “B7 hex”.
Related Publications
You may need to refer to the following related publications:
Publication Title Description
Publication
Number
Dataliner DL40 Plus Message
Display User Manual
Provides installation, wiring and
operating instructions for the DL40
Plus display (not slave display). Also
describes use of the onboard
message editor.
2706-6.1
DL40 Plus Offline Programming
Software User Manual
Describes installation and use of the
DOS based message development
software for the DL40 Plus.
2706-6.2
PanelBuilder Software
User Manual
Describes how to output messages
to the PanelView printer port for
display on the DL40 slave.
2711-6.0
PanelBuilder 1400e
Configuration Software for
Windows User Manual
Provides useful information when
using a PanelView enhanced
terminal as a master for a DL40 Plus
slave.
2711e-819