Set flashing mode (esc g 2) -5, Clear flashing mode (esc g 0) -5, Exit monitor mode (esc u) or (esc x) -6 – Rockwell Automation 2706-LV2S_LV4S DL40 PLUS SLAVE USER MANUAL User Manual

Page 43: Display status (esc h) -6

Publication 2706-6.3

6-4

Terminal Mode

Set Flashing Mode (ESC G 2)

(1B, 47, 32 hex)

Enables flashing text mode. All characters received after this
command are displayed flashing until disabled with a Clear Flashing
Mode command.

Clear Flashing Mode (ESC G 0)

(1B, 47, 30 hex)

Disables flashing text mode.

Monitor Mode (ESC U)

(1B, 55 hex)

Displays all control codes as custom characters. These characters
represent the hexadecimal value of the control code. Any command
associated with the control code is ignored.

Exit Monitor Mode (ESC u) or (ESC X)

(1B, 75 hex) or (1B, 58 hex)

Exits Monitor Mode.

Display Status (ESC h)

(1B, 68 hex)

Displays the status of the display as defined by the DIP switches.
This is the same configuration text displayed on powerup (see page 3-
13) without product version text and pixel test. After displaying the
status information, the screen is cleared with the cursor in the leftmost
position on the first line.