Rockwell Automation 2706-LV2S_LV4S DL40 PLUS SLAVE USER MANUAL - Manual (Page 37)

Publication 2706-6.3
5-2 PanelView (PV) Slave Mode
Display Options
Use the following control codes to control the appearance of
messages displayed in PV Mode.
[Ctrl][F] $ DAN
Flash code. Send the [Ctrl][F] command when you want the display
characters to flash. All characters following the first flash code in a
message flash. If two [Ctrl][F] codes appear in a message, only the
characters between the codes flash.
You can turn flash on and off multiple times in a message. At the start
of each new line of message text, the flash option is turned off.
[Ctrl][G] % DAN
This command energizes the DL40 Plus Slave relay. Display text is
not affected.
[Ctrl][L] + DAN
Form feed code. Sending a [Ctrl][L] command clears the display and
moves the cursor to the upper left corner of the display. Flash mode is
set to non-flashing. The relay is not affected.
[Ctrl][M] , DAN
Carriage return command. Sending the [Ctrl][M] command
terminates the current message line, sets the flash mode to non-
flashing, and moves the cursor to the beginning of the current line.
The relay is not affected.
If the Auto New Line DIP switch is enabled (see Chapter 2), the
cursor is also moved down to the start of the next line. If the cursor is
at the last line, the first line is cleared and the lines are shifted up.
Note: The cursor is not moved until the next displayable character is
received. This allows the current text to be displayed for the longest
period of time before being shifted or cleared.
[Ctrl][R] DAN
Relay reset command. Sending a [Ctrl][R] command de-energizes the
relay. Displayed text is unchanged.
[Ctrl][J] ) DAN
Line Feed command. Send a [Ctrl][J] command to move the cursor
down to the next line. If the cursor is on the last line, it remains on the
last line and all of the lines are shifted up (first line is removed).
Note: The cursor is not moved until the next displayable character is
received. This allows the current text to be displayed for the longest
period of time before being shifted or cleared.