Rockwell Automation 2706-LV2S_LV4S DL40 PLUS SLAVE USER MANUAL - Manual (Page 21)

Publication 2706-6.3
3-4 Installation and Startup
Electrical Precautions
Install the DL40 Plus Slave display conforming to NFPA 70E,
Electrical Safety Requirements for Employee Workplaces. In addition
to the NFPA general guidelines, refer to the following:
Careful cable routing helps minimize electrical noise. Route
incoming power to the module by a separate path from the
communication cables.
Do not run communications wiring and power wiring in the
same conduit!
Where communication and wire paths must cross, make their
intersection perpendicular.
Grounding helps limit the effects of noise due to electromagnetic
interference (EMI). To avoid problems caused by EMI, properly
ground all equipment and use shielded cables.
Input Voltage Requirements
Before connecting the DL40 Plus Slave to the incoming power, verify
that the power source provides:
100-240 Volts AC, 50/60 Hz, 0.60 - 0.25 amperes
Important: Power, input and output (I/O) wiring must be in
accordance with Class I, Division 2 wiring methods
[Article 501-4(b) of the National Electrical Code,
NFPA70] and in accordance with the local authority
having jurisdiction.
Hazardous Location Installations
!
ATTENTION: THIS EQUIPMENT IS SUITABLE
FOR USE IN CLASS I, DIVISION 2, GROUPS A, B,
C AND D, OR NON-HAZARDOUS LOCATIONS
ONLY.
!
ATTENTION: EXPLOSION HAZARD -
SUBSTITUTION OF COMPONENTS MAY IMPAIR
SUITABILITY FOR CLASS 1, DIVISION 2.
!
ATTENTION: EXPLOSION HAZARD - DO NOT
CONNECT OR DISCONNECT EQUIPMENT
UNLESS POWER HAS BEEN SWITCHED OFF OR
THE AREA IS KNOWN TO BE NON-HAZARDOUS.