Rockwell Automation 2706-LV2S_LV4S DL40 PLUS SLAVE USER MANUAL - Manual (Page 18)

Publication 2706-6.3
Chapter
3
Installation and Startup
Chapter Objectives
This chapter describes how to mount and make electrical connections
to the DL40 Plus Slave display. The following topics are described:
• Mounting Instructions
• Panel Cutout Dimensions
• RS-232 Connections
• RS-485 Connections
• Relay Connections
• Power Connections
• Powerup Sequence
Mounting the DL40 Plus Slave
The following pages provide panel cutout dimensions and overall
dimensions for the DL40 Plus Slave displays.
You can also mount the DL40 Plus Slaves in a custom panel or
enclosure. When a DL40 plus is properly installed, the faceplate of
the DL40 Plus Slave provides a NEMA Type 12, 13, and 4X(indoor)
rating. To install the DL40 Plus Slave:
1. Cut and drill the appropriate mounting holes in the enclosure or
panel.
2. Remove the six mounting nuts from the hardware bag provided
with the display.
3. Position the DL40 Plus Slave in the panel or enclosure mounting
hole.
4. Install and alternately tighten the nuts to a torque of 10in • lbs
(1.13N • m).