Slc/scanner configuration, Slc/scanner configuration -33 – Rockwell Automation 1747-SN Remote I/O Scanner User Manual

Page 77

Publication 1747-UM013B-EN-P - January 2005

Scanner Configuration and Programming 4-33

For more information on slot addressing, refer to your ASB module
user manual.

Note that slot addressing (e.g., 1/2-, 1-, and 2-slot) may not apply to
all types of RIO devices. Refer to each RIO device’s user manual to
determine the type of slot addressing required.

SLC/Scanner Configuration

Your SLC 5/02 processor can be programmed with an HHT

(1)

(Hand-Held Terminal). Although the configuration steps are similar,
they are not identical. Therefore, the following basic steps are
provided. For specific instructions, refer to the user manual included
with your programming device. For more information on M and G
files, refer to appendix B.

1. Locate an open slot in your SLC chassis. Remember that you

must use an SLC 5/02 or later processor.

2-Slot
Addressing

Two slots are addressed as one logical group.

1-Slot
Addressing

One slot is addressed as one logical group.

1/2-Slot
Addressing

One slot is addressed as two logical groups.

Slot 1

Slot 2

Slot 1

Slot 2

Input Image

Output Image

Remote Chassis

(1) The SLC 5/03 and SLC 5/04 processors cannot be programmed with the HHT.