Rockwell Automation 1747-SN Remote I/O Scanner - Manual (Page 68)

Publication 1747-UM013B-EN-P - January 2005
4-24 Scanner Configuration and Programming
Device Fault bit. If the Communications Attempted bit is 1, the
Enabled Device Fault bit is valid.
RIO Baud Rate Status
Word 2, bits 0 to 1 - displays the RIO communication/baud rate you
have set the scanner to via its DIP switch. Writing to word 2 does not
change the scanner baud rate.
As illustrated by the table below, bit 0 = SW1 and bit 1 = SW2.
Logical Device Starting Address Status
Word 8 - provides status/feedback of the logical device starting
addresses you configured in word 1 of the G file (primary/normal
logical devices). Writing to M1 file word 8 will not alter the contents of
the G file.
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
1 1 x x x x x x x x x x x x x x M1:e.0
M1 File
Communications
Attempted
Status Bit
Bit Number (decimal)
M1 (Status) File W ord 0
General Communication Status Word, Word 0
Enable Device
Fault Bit
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
1 0 x x x x x x x x x x x x x x RIO Baud Rate, Word 2
M1 File
M1:e.2
Baud Rate
M1 (Status) File - W ord 2
Bit Number (decimal)
Bit 1 - 0 Baud Rate SW 1 - 2
11 57.6K Baud 11
01 115.2K Baud 10
10 230.4K Baud 01
00 230.4K Baud 00