Rockwell Automation 1769-SM1 Compact I/O to DPI/SCANport Module - Manual (Page 124)

B-6 Module Parameters
38 [Data Rate 3]
Displays the data rate used by the CH3 drive. This
data rate is set in the drive, and the module
detects it. Default: 0 = 125 kbps
Values: 0 = 125 kbps
1 = 500 kbps
Type: Read Only
39 [Ref/Fbk Size 3]
Displays the size of the Reference and Feedback
for the CH3 drive. The drive determines the size of
the Reference and Feedback. Default: 0 = 16-bit
Value: 0 = 16-bit
1 = 32-bit
Type: Read Only
40 [Datalink Size 3]
Displays the size of each Datalink word for the
CH3 drive. The drive determines the size of
Datalinks. Default: 0 = 16-bit
Values: 0 = 16-bit
1 = 32-bit
Type: Read Only
41 [I/O Config 3]
Sets the I/O that is transferred through the module
to the CH3 drive. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read/Write
Reset Required: Yes
42 [I/O Actual 3]
Displays the Reference/Feedback and Datalinks
actively transmitted by the module for the CH3
drive. The value of this parameter will usually be
equal to the value of Parameter 41 - [I/O Config 3]. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read Only
Parameter
No. Name and Description
Details
Bit
Definition
No
t Use
d
No
t Use
d
No
t Use
d
Dat
alink D
Dat
alink C
Dat
alink B
Dat
alink A
Cmd
/Sts
Default x x x 0 0 0 0 1
Bit 7 6 5 4 3 2 1 0
Bit
Definition
No
t U
sed
No
t U
sed
No
t U
sed
D
ata
link
D
D
ata
link
C
D
ata
link
B
D
ata
link
A
Cm
d/
S
ts
Default x x x 0 0 0 0 1
Bit 7 6 5 4 3 2 1 0