Rockwell Automation 1769-SM1 Compact I/O to DPI/SCANport Module - Manual (Page 120)

B-2 Module Parameters
02 [Reset Module]
No action if set to “Ready.” Resets the module if
set to “Reset Module.” Restores the module to its
factory default settings if set to “Set Defaults.” This
parameter is a command. It will be reset to “0 =
Ready” after the command has been performed. Default: 0 = Ready
Values 0 = Ready
1 = Reset Module
2 = Set Defaults
Type: Read/Write
Reset Required: No
03 [Port ID 1]
Displays the port number to which CH1 is
connected. Default: 0
Minimum: 0
Maximum: 7
Type: Read Only
04 [Data Rate 1]
Displays the data rate used by the CH1 drive. This
data rate is set in the drive, and the module
detects it. Default: 0 = 125 kbps
Values: 0 = 125 kbps
1 = 500 kbps
Type: Read Only
05 [Ref/Fbk Size 1]
Displays the size of the Reference and Feedback
for the CH1 drive. The drive determines the size of
the Reference and Feedback. Default: 0 = 16-bit
Value: 0 = 16-bit
1 = 32-bit
Type: Read Only
06 [Datalink Size 1]
Displays the size of each Datalink word for the
CH1 drive. The drive determines the size of
Datalinks. Default: 0 = 16-bit
Values: 0 = 16-bit
1 = 32-bit
Type: Read Only
07 [I/O Config 1]
Sets the I/O that is transferred through the module
to the CH1 drive. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read/Write
Reset Required: Yes
08 [I/O Actual 1]
Displays the Reference/Feedback and Datalinks
actively transmitted by the module for the CH1
drive. The value of this parameter will usually be
equal to the value of Parameter 07 - [I/O Config 1]. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read Only
Parameter
No. Name and Description
Details
!
ATTENTION: Risk of injury or equipment damage exists. If the module is
transmitting I/O that controls the drive, the drive may fault when you reset the
module. Determine how your drive will respond before resetting the module.
Bit
Definition
Not Used Not Used Not Used Datalink
D
Datalink
C
Datalink
B
Datalink
A
Cmd/Sts
Default x x x 0 0 0 0 1
Bit 7 6 5 4 3 2 1 0
Bit
Definition
No
t Used
No
t Used
No
t Used
Dat
alink
D
Dat
alink
C
Dat
alink
B
Dat
alink
A
Cmd/Sts
Default x x x 0 0 0 0 1
Bit 7 6 5 4 3 2 1 0