Rockwell Automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User Manual - Manual (Page 97)

Chapter 6
Using the Ethernet Interface
6-16
FTP Get Session
The following example shows how you might conduct an FTP get session.
Important: The following ftp get session is an example only. It
represents how one network is set up and we accomplished an FTP session.
For this example session, we continue the previous FTP send session and
retrieve the file we sent to a remote directory.
1. At the ftp prompt, type get and press [Return] . See Figure 6.16.
Figure 6.16
FTP Get
2. At the ( remote-file ) prompt, enter the name of the file that you
want to transfer from the remote host.
3. At the ( local-file ) prompt, enter the name that you want to
assign the file on the control coprocessor. You get a listing of user
information confirming the transfer.
4. At the ftp prompt, type close and press [Return] to close the
connection to the remote host. The Goodbye line confirms the
termination of the connection.
5. At the ftp prompt, type quit and press [Return] to exit FTP. The
OS-9 $ prompt appears.
6. At the $ prompt, type list hosts.othernode and press
[Return] to view the contents of the file just received from the
remote system. It is the same as the file sent.