Rockwell Automation 1395 DC Drive, 800-1250 Hp, FRN 5.XX-9.30 - Manual (Page 163)

Chapter 5
Programming Parameters
5-72
Parameter 908 – Trend Constant Unsigned Value [Trend Unsign
Val]
Internal units : None
Programming Terminal units: None
Minimum Value: 0
Maximum Value: 65535
Default Value: 0
Description: This parameter specifies an unsigned constant value
used for trend trigger evaluation. This parameter number is entered
when programming Trend Operand Parameter X or Y.
Parameter 909 – Trend Constant Unsigned Value [Trend Unsign
Val]
Internal units : None
Programming Terminal units: None
Minimum Value: 0
Maximum Value: 65535
Default Value: 0
Description: This parameter specifies an unsigned constant value
used for trend trigger evaluation. This parameter number is entered
when programming Trend Operand Parameter X or Y.
Parameter 910 – Trend 1 Operand Parameter X [Tr 1 Opnd X
Param]
Internal units : None
Programming Terminal units: None
Minimum Value: 1
Maximum Value: 947
Default Value: 100
Description: This parameter specifies the first of two parameter
numbers for the trend trigger evaluation. The data value for the
entered parameter number is used in the trigger evaluation.
Parameter 911 – Trend 1 Operand Parameter Y [Tr 1 Opnd Y
Param]
Internal units : None
Programming Terminal units: None
Minimum Value: 1
Maximum Value: 947
Default Value: 904
Description: This parameter specifies the second of two parameter
numbers used for the trend trigger evaluation. The data value for the
entered parameter number is used in the trigger evaluation.