View & configure parameters, Introduction, View & edit – Rockwell Automation 193-DNENCATR EtherNet/IP Communications Auxiliary User Manual User Manual
Page 43: Chapter 5, Introduction view & edit
Rockwell Automation Publication 193-UM014B-EN-P December 2011
43
Chapter
5
View & Configure Parameters
Introduction
In this chapter, you will be able to view and configure parameters for a DeviceNet
device that supports the full implementation of the Parameter Object.
View & Edit
The EtherNet/IP Commuications Auxiliary is able to view and configure
parameters for a DeviceNet device that supports the full implementation of the
Parameter Object. Users can use the web interface to view and edit parameters for
a DeviceNet Module in the scan list.
Follow the steps below to view and edit parameters using the web interface of the
EtherNet/IP Commuications Auxiliary.
1.
Navigate to Scan List>Configuration, then select the DeviceNet device
folder to view or edit its parameters. The selected DeviceNet device folder
will expand.