Rockwell Automation 20-750-BNETIP BACnet/IP Option Module - Manual (Page 56)

56 Rockwell Automation Publication 750COM-UM005B-EN-P - June 2014
Chapter 6 Viewing Option Module Web Pages
Configure E-mail
Notification Web Page
The Configure E-mail Notification web page contains selections and data fields
for configuring the option module to automatically send email messages to
desired addresses when selected types of events occur. To view this web page, click
the ‘Configure e-mail’ link (highlighted in
Figure 8 ) in the navigation pane.
Figure 8 - Example of Configure E-mail Notification Web Page
By default, settings are not protected. After configuration, settings can be
protected by using
Device Parameter 27 - [Web Features] to set E-mail Cfg Bit 0
value to ‘0’ (Disabled). To change a protected configuration, it must first be
unprotected by setting the E-mail Cfg Bit 0 value back to ‘1’ (Enabled).
To configure e-mail notification, perform the following steps.
1. Click the desired ‘Send an e-mail message when’ check boxes you want to
occur that will send e-mail notification.
If you want email notification only when selected faults/alarms occur:
a. Click the respective fault and/or alarm radio buttons.
b. Click the ‘selected faults’ link and/or ‘selected alarms’ link.
c. Click the desired fault/alarm check boxes.
d. Click Save Changes.
e. Click the ‘Back to E-mail Configuration Page’ link.