Rockwell Automation 20-750-BNETIP BACnet/IP Option Module - Manual (Page 25)

Rockwell Automation Publication 750COM-UM005B-EN-P - June 2014 25
Chapter
3
Configuring the Option Module
This chapter provides instructions and information for setting the parameters to
configure the option module.
For a list of parameters, see Appendix B , Option Module Parameters. For
definitions of terms in this chapter, see the Glossary .
Configuration Tools
The option module stores parameters and other information in its own
nonvolatile storage (NVS) memory. You must, therefore, access the option
module to view and edit its parameters. The following tools can be used to access
the option module parameters.
Topic Page
Configuration Tools 25
Using the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM to Access Parameters 26
Setting the Option Module Address Using Parameters 26
Setting the Device Instance 28
Setting the Device Port 29
Setting a Fault Action 29
Setting the Comm Loss Time 31
Setting Web Page Access 32
Resetting the Option Module 33
Restoring Option Module Parameters to Factory Defaults 34
Viewing the Option Module Status Using Parameters 35
Updating the Option Module Firmware 35
Tool See
PowerFlex 20-HIM-A6 or
20-HIM-C6S HIM
page 26
Connected Components Workbench
software, version 1.02 or later
http://www.ab.com/support/abdrives/webupdate/
software.html , or online help (installed with the software)
DriveExplorer software,
version 6.01 or later
http://www.ab.com/drives/driveexplorer , or online help
(installed with the software)
DriveExecutive software,
version 5.01 or later
http://www.ab.com/drives/drivetools , or online help
(installed with the software)
IMPORTANT For the HIM screens shown throughout this chapter, the option module
was installed in drive Port 4. If your option module is installed in a
different drive port, that port would appear instead of Port 4.