Rockwell Automation 20-750-BNETIP BACnet/IP Option Module - Manual (Page 13)

Rockwell Automation Publication 750COM-UM005B-EN-P - June 2014 13
Getting Started Chapter 1
You can view option module
Device parameters and Host parameters with any of
the following drive configuration tools:
• PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM—use the
or
key to scroll to the drive port in which the module resides, press the
(Folders) key, and use the or key to scroll to the DEV PARAM
or HOST PARAM folder.
• Connected Components Workbench software—click the tab for the
option module at the bottom of the window, click the Parameters icon in
the tool bar, and click the
Device or Host Parameters tab.
• DriveExplorer software—find the option module in the treeview and open
its Parameters folder.
• DriveExecutive software—find the option module in the treeview, expand
the module in the tree, and open its Parameters folder.
Compatible Products
At the time of publication, the option module is compatible with the following
products:
• PowerFlex 753 drives (all firmware revisions)
• PowerFlex 755 drives (all firmware revisions)
Required Equipment
Some of the equipment that is required for use with the option module is shipped
with the module, but some you must supply yourself.
Equipment Shipped with the Option Module
When you unpack the option module, verify that the package includes the
following:
User-Supplied Equipment
To install and configure the option module, you must supply the following:
❑ One 20-750-BNETIP BACnet/IP Option Module
❑ One Network Communication Option Module Installation Instructions,
publication 750COM-IN002
❑ A small screwdriver
❑ Ethernet Cable