Blade ICE RACKSWITCH G8124-E - Manual (Page 57)

BLADEOS 6.5.2 Application Guide
BMD00220, October 2010 Chapter 3: Securing Administration 57
Configuring the SCP Administrator Password
To configure the SCP-only administrator password, enter the following command (the default
password is
admin ):
Using SSH and SCP Client Commands
This section shows the format for using some client commands. The examples below use
205.178.15.157 as the IP address of a sample switch.
To Log In to the Switch
Syntax:
Note – The -4 option (the default) specifies that an IPv4 switch address will be used. The -6
option specifies IPv6.
Example:
To Copy the Switch Configuration File to the SCP Host
Syntax:
Example:
RS G8124(config)# [no] ssh scp-password
Changing SCP-only Administrator password; validation required...
Enter current administrator password:
Enter new SCP-only administrator password:
Re-enter new SCP-only administrator password:
New SCP-only administrator password accepted.
>> ssh [-4|-6]
-or-
>> ssh [-4|-6] @
>> ssh [email protected]
>> scp [-4|-6] @ :getcfg
>> scp [email protected]:getcfg ad4.cfg