Blade ICE RACKSWITCH G8124-E - Manual (Page 48)

BLADEOS 6.5.2 Application Guide
48 Chapter 2: Initial Setup BMD00220, October 2010
4. If configuring VLANs, specify a VLAN for the interface.
This prompt appears if you selected to configure VLANs back in Part 1:
Enter the number for the VLAN to which the interface belongs, or press without specifying
a VLAN number to accept the current setting.
5. At the prompt, enter y to enable the IP interface, or n to leave it disabled:
6. The system prompts you to configure another interface:
Repeat the steps in this section until all IP interfaces have been configured. When all interfaces have
been configured, press without specifying any interface number.
Current VLAN: 1
Enter new VLAN [1-4094]:
Enable IP interface? [y/n]
Enter interface number: (1-128)