beautypg.com

Loading a new switch image, Loading a saved switch configuration – Blade ICE RACKSWITCH G8124-E User Manual

Page 365

background image

BLADEOS 6.5.2 Application Guide

BMD00220, October 2010

Chapter 26: Simple Network Management Protocol 365

Loading a New Switch Image

To load a new switch image with the name “

MyNewImage-1.img

” into

image2

, follow the

steps below. This example shows an FTP/TFTP server at IPv4 address 192.168.10.10, though IPv6
is also supported.

1.

Set the FTP/TFTP server address where the switch image resides:

Set agTransferServer.0 "192.168.10.10"

2.

Set the area where the new image will be loaded:

Set agTransferImage.0 "image2"

3.

Set the name of the image:

Set agTransferImageFileName.0 "MyNewImage-1.img"

4.

If you are using an FTP server, enter a username:

Set agTransferUserName.0 "MyName"

5.

If you are using an FTP server, enter a password:

Set agTransferPassword.0 "MyPassword"

6.

Initiate the transfer. To transfer a switch image, enter 2 (gtimg):

Set agTransferAction.0 "2"

Loading a Saved Switch Configuration

To load a saved switch configuration with the name “MyRunningConfig.cfg” into the switch,
follow the steps below. This example shows a TFTP server at IPv4 address 192.168.10.10, though
IPv6 is also supported.

1.

Set the FTP/TFTP server address where the switch Configuration File resides:

Set agTransferServer.0 "192.168.10.10"

2.

Set the name of the configuration file:

Set agTransferCfgFileName.0 "MyRunningConfig.cfg"

3.

If you are using an FTP server, enter a username:

Set agTransferUserName.0 "MyName"

4.

If you are using an FTP server, enter a password:

Set agTransferPassword.0 "MyPassword"

5.

Initiate the transfer. To restore a running configuration, enter 3:

Set agTransferAction.0 "3"

This manual is related to the following products: