Blade ICE RACKSWITCH G8124-E - Manual (Page 207)

BLADEOS 6.5.2 Application Guide
BMD00220, October 2010 Chapter 14: FCoE and CEE 207
Assigning Priority Values to a Priority Group
Each priority group may be configured from its corresponding ETS Priority Group, available using
the following command:
where priority list is one or more 802.1p priority values (with each separated by a comma). For
example, to assign priority values 0 through 2:
Note – Within any specific PGID, the PFC settings (see “Priority-Based Flow Control” on
page 200 ) should be the same (enabled or disabled) for all priority values within the group. PFC can
be enabled only on priority value 3 and one other priority. If the PFC setting is inconsistent within
a PGID, an error is reported when attempting to apply the configuration. Also, no more than three
ETS Priority Groups may include priority values for which PFC is disabled.
When assigning priority values to a PGID, the specified priority value will be automatically
removed from its old group and assigned to the new group when the configuration is applied.
Each priority value must be assigned to a PGID. Priority values may not be deleted or unassigned.
To remove a priority value from a PGID, it must be moved to another PGID.
For PGIDs 0 through 7, bandwidth allocation can also be configured through the ETS Priority
Group menu. See for
“Allocating Bandwidth” on page 208 for details.
Deleting a Priority Group
A priority group is automatically deleted when it contains no associated priority values, and its
bandwidth allocation is set to 0%.
Note – The total bandwidth allocated to PGID 0 through 7 must equal exactly 100%. Reducing the
bandwidth allocation of any group will require increasing the allocation to one or more of the other
groups (see
“Allocating Bandwidth” on page 208 ).
RS G8124(config)# cee global ets priority-group
priorities
RS G8124(config)# cee global ets priority-group
priorities 0,1,2