Yamato Scientific CLS600 Cool Line - Manual (Page 8)

5
Before Using This Unit
Requirements for Installation
4. Do not modify
• Modification of this unit is strictly prohibited.
This could cause a failure.
5. Installation on horizontal surface
• Place this unit as flat a place as possible. If
the rubber feet (model CLS301) or casters
(models CLS400/600) are not in uniform
contact with the floor surface, noise or
vibration may result. Additionally, the unit
may cause a problem or malfunction.
6. Choose a correct power distribution board or receptacle
• Choose a correct power distribution board or receptacle that meets the unit’s rated electric
capacity.
Electric capacity: CLS301: 100V AC, 4A
CLS400: 100V AC, 6A
CLS600: 100V AC, 10A
NOTE)
There could be the case that the unit does not run even after turning ON the power. Inspect
whether the voltage of the main power is lowered than the specified value, or whether other
device(s) uses the same power line of this unit. If the phenomena might be found, change the
power line of this unit to the other power line.
7. Before/after installing
• It may cause injure to a person if this unit falls down or moves by the earthquake and the
impact. etc..To prevent, take measures that the unit cannot fall down, and not install to busy
place.
改 造
Modification