Yamato Scientific CLS600 Cool Line - Manual (Page 17)

14
Operation Method
Operation Mode and Function List
The operation functions of this unit are as follows;
Name Description Page
Calibration offset function
This calibration offset function is for calibrating the
difference occurred between the required in- bath
temperature and control temperature (sensor
temperature) of the controller. This unit can be
calibrated toward either plus side or minus side of
the whole temperature range.
26
Setting value locking
This function locks the established operation status.
It can be set and cancelled with the SUB MENU key.
27
Power failure compensation function
In case of electric outage during operation, the
operation will be started in the state just before the
electric outage.
It can be set or cancelled by SUB MENU key.
28
Addition time function
Time length while the Power supply is turned on is to
be added by 1 hour cycle.
It can be displayed by SUB MENU key.
29
Temperature Output Terminal
Transmits and outputs the measured temperature of
the controller at 4 to 20 mA.
30