Yamato Scientific CLS600 Cool Line - Manual (Page 46)

43
In the Event of Failure…
Trouble Shooting
Phenomenon Check point
The unit does not start to
operate although the earth
leakage breaker and POWER
switch are turned on.
• Check if the power cable is securely connected to the power
supply.
• Check if the power fails.
The ALARM lamp lights on.
• Check if the external water tank is filled with a circulating fluid.
The temperature does not drop.
• Check if the set temperature is higher than the inside
temperature of the bath.
• Check if the condenser filter is contaminated.
The circulating pump produces
unusual noise.
• Check if air remains in the circulating pump.
™
Turn off the power, and open the air release valve in the back of the
system to let out air.
The circulating fluid does not
circulate.
• Check if the insulation hose with a priming pump is properly
connected. (Refer to page 7.)
• Check if the quantity of fluid inside the external water tank is
sufficient.
• Operate the priming pump more frequently and retry.
"REFRIGERATO ERROR" lamp
lights on.
• Check if the condenser filter is dirty.
• Check if the room temperature is high.
The displayed temperature does
not match the measured
temperature.
• Check if the set value of calibration offset is other than "0". Set
it at "0". (Refer to page 26.)
When a power failure occur
If the unit was deactivated in the middle of operation due to a power failure and is re-energized, the unit
automatically returns to the state just before the power failure and resumes operation. (To know the
setting method of this function, refer to page 28 "Power Failure Compensation Function".)
If the resumption of operation by automatic recovery is inconvenient, turn off the leakage breaker.
In the case if the error other than listed above occurred, turn off the POWER switch and primary
power source immediately. Contact the shop of your purchase or nearest Yamato Scientific
Service Office.