Yamato Scientific CLS600 Cool Line - Manual (Page 19)

16
Operation Method
Fixed Temperature Operation
In this mode, the unit starts to operate by pressing RUN/STOP key and continues operating at the set
temperature until RUN/STOP key is re-pressed, as shown in the figure below.
温度（℃）
時間（t）
SV:温度設定値
SV
ｽﾀｰﾄ/ｽﾄｯﾌﾟ ｷｰON ｽﾀｰﾄ/ｽﾄｯﾌﾟ ｷｰOFF
Fixed temperature
operation procedure
1. Turn on the earth leakage breaker/ POWER switch
• When the earth leakage breaker and POWER switch are turned
on, a starting screen will be displayed for about 4 seconds.
PUMP lamp is to be lit, the pump starts operating, and the
circulation starts. After starting operation, the initial setting
screen will be displayed. Each screen shows the current inner
bath temperature and setting temperature.
2. Set the temperature
• Set the proper temperature by ▼▲ key.
The setting value will be smaller by ▼ key, and larger by ▲
key.
• Setting value will blink at the setting temperature screen.
Measurement temperature screen:
Displays the current temperature in bath.
Setting temperature screen:
Displays the setting temperature.
TEMP.
RUN/STOP key: ON RUN/STOP key: OFF
TIME
SV: Set Temp.