Yamato Scientific CLS600 Cool Line - Manual (Page 24)

21
Operation Method
Auto Stop Operation
3. Select auto stop operation
• Press TIMER key, and display the character "AStP" which means
auto stop operation.
• Measured temperature screen:
"AStP" which means auto stop operation is displayed.
• Setting temperature screen:
The time which is set just before is displayed.
4. Set the timer
• Setting value will blink at setting temperature screen.
• Set the proper time by ▼▲ key.
The setting value will be smaller by ▼ key, and larger by ▲
key.
Timer function:
• The maximum setting time is "999 hours and 50 minutes".
• The time can be set in increments of a minute under 99 hours
and 59 minutes.
• It can be set in increment of ten minutes over 100 hours.
• The
"▼▲" can change the setting time quickly when it is pressed
continuously. Press them discontinuously when fine adjustment
is needed.
5. Start timer operation
• Press RUN/STOP key for a second.
• AUTO STOP lamp blinks and the operation will start.
• Timer operation starts when the inner bath temperature at the
measured temperature screen reaches the setting temperature.
• During timer operation, the remaining time is displayed at the
setting temperature screen.