Yamato Scientific CLS600 Cool Line - Manual (Page 26)

23
Operation Method
Auto Start Operation
In this mode, the unit automatically starts to operate after the set period passes away from the start of
fixed temperature operation according to timer setting, as shown in the figure below. However, it does not
automatically come to a stop and must be manually deactivated.
温度（℃）
時間（t）
SV:温度設定値
PV:温度表示値
SV
ｽﾀｰﾄ/ｽﾄｯﾌﾟ ｷｰON ｽﾀｰﾄ/ｽﾄｯﾌﾟ ｷｰOFF
ﾀｲﾏ起動 ﾀｲﾑｱｯﾌﾟ
PV
ﾀｲﾏｽﾀｰﾄ
Auto start operation
procedure
1. Turn on the earth leakage breaker/ POWER switch
• When the earth leakage breaker and POWER switch are turned
on, a starting screen will be displayed for about 4 seconds.
PUMP lamp is to be lit, the pump starts operating, and the
circulation starts. After starting operation, the initial setting
screen will be displayed. Each screen shows the current inner
bath temperature and setting temperature.
2. Set the temperature
• Set the proper temperature by ▼▲ key.
The setting value will be smaller by ▼ key, and larger by ▲
key.
• Setting value will blink at the setting temperature screen.
™
Temperature can be changed during operation.
TEMP.
RUN/STOP key: ON RUN/STOP key: OFF
TIME
SV: Set Temp.
PV: Current Temp.
Timer starts Time-up
Timer Operation
Measurement temperature screen:
Displays the current temperature in bath.
Setting temperature screen:
Displays the setting temperature.