Yamato Scientific CLS600 Cool Line - Manual (Page 54)

51
Installation Standard Manual
Install the unit according the procedure described below (check options and special specifications
separately).
Model Serial number Date
Person in charge of installation
(company name)
Person in charge of
installation
Judgment
№ Item Method Reference operation manual Judgment
Specifications
1 Accessories
Check the quantities of accessories with
the quantities shown in the Accessory
column.
Specification P.45
・ Visually check the surrounding area.
Caution: Pay attention to the ambient
environment.
・
Keep space.
Before Using This Unit
"2. Choose a proper place for
installation" P.4
2 Installation
・ Pour water into the water bath.
Caution: Air release.
Before Using This Unit
"Installation Procedure"
P.7
Operation
Before Using This Unit
"1. Always ground this unit"
P.4
Before Using This Unit
"6. Choose a correct power
distribution board or receptacle"
P.5
1 Power voltage
・ Using a tester, measure the voltage of
the voltage used by the customer
(distribution board, outlet, etc.).
・ Measure the voltage during operation
(the voltage must be within the
standard).
Caution: When a unit is to be connected
to the plug or breaker, use one that
conforms to the standard.
Specification P.45
Before Using This Unit
"Installation Procedure"
P.7
2
Start of
operation
・ Start operation.
The circulating water must circulate.
Set the temperature at 20°C to confirm
the state.
Check: Water leakage is not permissible.
Operation Method P.13
Description
1
Description of
operation
Explain the operation of each unit to the
customer according to this Operation
Manual.
All
2 Error code
Explain error codes and the procedure for
resetting them to the customer according
to this Operation Manual.
In the Event of Failure… P.42
3
Maintenance
inspection
Explain the operation of each unit to the
customer according to this Operation
Manual.
Maintenance Method P.39
4
Completion of
installation
Information to
be entered
・ Enter the date of installation and the
name of the person in charge of
installation on the face plate on the
unit.
・ Enter necessary information on the
guarantee, and pass it to the customer.
・ Explain the after-sale service route to
the customer.
After Service and Warranty P. 44