SATEC BFM136 - Manual (Page 50)

‎Chapter 4 PAS Application Software Configuring Billing Energy and TOU Registers
50 BFM136 Branch Feeder Monitor
Parameter Options Default Description
Billing/TOU Registers
Units kWh, kvarh, kVAh None The register measurement units. It is set
automatically.
Register Source List
Source
Input None
kWh IMPORT
kWh EXPORT
kvarh IMPORT
kvarh EXPORT
kVAh TOTAL
Submeter 1 -
Submeter 40
1
None Links an energy source to the target
register of all metering submeters, or links
all registers of a source submeter to a
totalization submeter.
Multiplier 0.001 to 100.000 0.100 The multiplication factor for the energy
source.
Target Reg#1- Reg#3
Submeter 1 -
Submeter 40
1
None Defines the target register for the energy
source. It is set automatically for target
energy registers.
1 Linking a submeter to another totalization submeter connects all its
configured energy registers to the corresponding registers of the target
submeter.
Totalization Submeters
If you wish to automatically totalize energy measured by a number of
submeters by using a separate totalization submeter, select a source
submeter in the Source Input column on the Register Source List pane
(starting with source 5), and then select the desired target totalization
submeter in the Target column. Repeat these steps for all source submeters
while selecting the same totalization submeter as the target.
Selecting a submeter as a target automatically connects all active energy
registers of the source submeters to its energy registers, thus making it a
totalization submeter. Note that each totalization submeter takes its own
communication address in a sequential order along with the metering
submeters (see
Submeter Addressing ).
Configuring the Daily Tariff Schedule
To configure your daily tariff schedule, select Energy/TOU from the Meter
Setup menu, and then click on the TOU Daily Profiles tab.
The daily profile setup allows you to specify the daily tariff change points with
a 15-minute resolution for six tariffs and four seasons.