MacDon D65 SP DHOM - Manual (Page 83)

OPERATION
7. Check that divider does NOT move laterally. Adjust
bolts (A) as required to tighten divider and remove
lateral play when pulling at divider tip.
8. Close/install endshields.
Figure 4.53: Crop Divider
Installing Crop Dividers on Header without Latch Option
To install crop dividers on a header without the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator’s manual for instructions regarding the proper use and storage of header safety props.
1. Lower reel, raise header, stop engine, remove key, and
engage safety props. For instructions, refer to your
windrower operator’s manual.
2. Open/remove endshields. Refer to 4.2.3 Endshields,
page 37 .
3. Remove crop divider from storage.
4. Position crop divider as shown by locating lugs (A) in
holes in endsheet.
Figure 4.54: Crop Divider
169899 71 Revision A