MacDon D65 SP DHOM - Manual (Page 189)

MAINTENANCE AND SERVICING
1. Apply talc (baby powder) or talc/graphite lubricant mix
to the draper surface that forms the seal with the cutter
bar and to the underside draper guides.
2. Insert draper into deck at outboard end, under the
rollers. Pull draper into deck while feeding it at the end.
3. Feed in the draper until it can be wrapped around the
drive roller.
4. Similarly, insert the other end into the deck over the
rollers. Pull draper fully into the deck.
Figure 6.102: Installing Draper
5. Loosen the rear deck deflector (A) by loosening
mounting
bolts (B). This may help with
draper installation.
Figure 6.103: Backsheet Deflector
6. Attach ends of draper with tube connectors (B),
screws (A) with heads facing the center opening,
and nuts.
7. Adjust tension. Refer to 6.7.3 Adjusting Draper
Tension, page 178 .
Figure 6.104: Draper Connector
169899 177 Revision A