9replacing draper deflectors, Removing wide draper deflectors, Replacing draper deflectors – MacDon D65 SP DHOM User Manual
Page 207: 9 replacing draper deflectors
7.
Tension the draper, with tensioner bolt (A) and follow
the directions on the decal for proper draper tensioning.
8.
Disengage the reel and header safety props.
9.
Start the engine and lower header and reel.
10. Run machine to verify that draper tracks correctly.
11. If adjustment is required, refer to
Header Draper Tracking, page 184
Figure 6.141: Draper Tensioner
6.7.9
Replacing Draper Deflectors
Removing Wide Draper Deflectors
To remove draper deflector, follow these steps: Left end removal is illustrated.
1.
Raise reel fully and lower header to ground.
2.
Shift decks to allow work space at one end of header if hydraulic deck shift installed, otherwise move decks
manually after shutting down windrower.
3.
Stop engine, remove key, and engage reel safety props.
4.
Open endshield.
5.
Loosen nuts (A) on cutterbar until retainer (B) is loose.
Figure 6.142: Deflector Retainer
169899
195
Revision A