MacDon D65 SP DHOM - Manual (Page 102)

OPERATION
4.15.3 Converting from Transport to Field Position
To convert the header from Transport to Field position, follow these steps.
Removing Tow-Bar
Remove tow-bar as follows:
1. Block the tires to prevent header rolling, and unhook
from towing vehicle.
2. Disconnect wiring connector (A) on tow-bar.
3. Remove pin (B) from tow-bar and disassemble outer
section (C) from inner section (D).
Figure 4.71: Tow-Bar Assembly
A - Wiring Connector B - Pin
C - Outer Section D - Inner Section
4. Disconnect wiring connector (A) at front wheel.
Figure 4.72: Wiring Connector
169899 90 Revision A