MacDon D65 SP DHOM - Manual (Page 225)

MAINTENANCE AND SERVICING
NOTE:
A pair of modified channel lock pliers is recommended
to install the bushing clamps. Secure pliers (A) in vice
and grind in a notch (B) at the end of each arm that fits
the clamp (C).
Figure 6.183
Cam End Bushings
1. Position bushing halves (B) on tine tube with flangeless
end adjacent to reel arm, and locate lug in each
bushing half in hole in tine tube.
2. Slide tine tube (A) toward tail end of reel to insert the
bushing (B) into the reel arm. If tine tube supports are
installed, ensure that the bushings at those locations
slide into the support.
3. Re-install fingers or tines if removed. Refer to:
• Installing Steel Tines, page 205
• Installing Plastic Fingers, page 207
Figure 6.184: Cam End
4. Install bushing clamp (A) onto tine tube adjacent to
flangeless end of bushing (B).
5. Position clamp (A) on bushings (B) so that edges
of clamp and bushing are flush when clamp fits into
groove on bushing and lock tabs are engaged.
Figure 6.185: Bushing
169899 213 Revision A