MacDon D65 SP DHOM - Manual (Page 150)

MAINTENANCE AND SERVICING
Greasing Procedure
Greasing points are marked on the machine by decals showing a grease gun and grease interval in hours of
operation. Master grease point location decals as shown below are provided on the header.
Use the recommended lubricants specified in this manual.
Refer to
6.2.2 Recommended Fluids and Lubricants, page
115 .
CAUTION
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
Figure 6.26: Use Only
Recommended Lubricants
1. Wipe grease fitting with a clean cloth before greasing
to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun until
grease overflows fitting (except where noted).
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. Remove and thoroughly clean any fitting that will
not take grease.
Also clean lubricant passageway.
Replace fitting if necessary.
6. Use clean High Temperature Extreme Pressure grease
as shown.
169899 138 Revision A