Brother HL-4000CN User Manual
Page 88
4-17
6.
Gently lift the end paper guide to move
it, and insert the pins at the bottom of
the guide in the holes (indicated by the
mark) corresponding to the paper
size that you want to load.
Make sure that the end guide is
properly inserted into the holes for the
paper size.
Look
9
Only a small amount of movement of
the end paper guide can make
automatic paper size detection
impossible. If this occurs, move the end
paper guide all the way to its outermost
position again, then realign it with the
appropriate paper size mark.
7.
Align the four corners of the paper
stack and insert the paper (print side
up) under the tab.
Look
Do not use paper that is folded,
creased, or heavily warped.
Make sure that all the paper is
under the tab.
Do not overload the paper tray.
8.
Align the side guides with the edges of
the paper.
Look
10
Pushing the paper guides too hard
against the edges of the paper stack
can cause a paper jam. However, if the
paper guides are too loose, the paper
may twist as it feeds through the
printer.
EDNord - Istedgade 37 A - 9000 Aalborg - telefon 96333500