2 setting protocols, Setting protocols – Brother HL-4000CN User Manual
Page 36
1-9
1
1
.
.
2
2
.
.
2
2
S
S
e
e
t
t
t
t
i
i
n
n
g
g
P
P
r
r
o
o
t
t
o
o
c
c
o
o
l
l
s
s
Look
2
When the printer is shipped from the factory, all protocols except FTP’ are active by
default. Normally you do not need to perform the operations described in this
section when you connect a new printer to a network for the first time. If you need to
change any of the default Protocol settings, follow the steps outlined in this section.
3
This concludes the printer settings. Move on to 1.2.3 “Confirming Settings”.
Supported Protocols
• For TCP/IP(LPD) → [LPD]
protocol
• For port 9100
→ [Port9100]
protocol
• For IPP
→ [IPP]
protocol
• For NetBIOS (transport protocol: TCP/IP) → [NetBIOS
TCP/IP]
protocol
• For NetBIOS (transport protocol: NetBEUI) → [NetBIOS NetBEUI] protocol
• For NetWare
→ [NetWare]
protocol
• For AppleTalk
→ [AppleTalk]
protocol
See
Refer to 5.2 “Basic Menu Operation” for information about the operation of the
control panel.
EDNord - Istedgade 37 A - 9000 Aalborg - telefon 96333500