T-armor, Drop valley - fixed – Metal Sales T-Armor Series User Manual

Page 72

T-ARMOR

DROP VALLEY - FIXED

INSTALLATION NOTES

#14-13 Deck Screws (1'-0" oc)

Clips w/ (2) #14-13 Deck Screws

Drop Valley

Tube Sealant (Between Panel Ribs)

Eave Plate

Double Bead Tape Sealant

Wood Blocking (by others)

T-Armor Panel

Bearing Plate

3:12 Slope

Minimum

All Eave and Drop Valley flashings must be installed prior

to panel installation.

1. Install new Eave Plate over top of rigid board insulation

and fasten through the Valley Plate and wood blocking

into the metal deck at 1'-0" oc.

2. Install new Drop Valley flashing on top of the Eave Plate.

3. If two or more flashings are required, lap the flashing

over the previously installed flashing by a minimum of

6", placing two beads of Tube Sealant between the

flashings. Locate beads of Tube Sealant so that it does

not press out of the lap. Do not install fasteners through

the Drop Valley lap.

4. Apply a continuous row of Double Bead Tape Sealant across the top of each side of the Drop Valley flashing.

5. Set panel into place and use #12-14

Self Driller XL screws to attach (see page 52).

6. Apply Tube Sealant up the side and across the top of the panel ribs before installing the next panel.

Moisture Barrier (by others)

Metal Decking

(by others)

#12-14x1

" SD XL (See Pg 52)

Additional #14-13 Deck

Screws may be required for

areas with large snow loads

*Panel cap not shown for clarity

9" max