T-armor, Box gutter - floating – Metal Sales T-Armor Series User Manual

Page 58

T-ARMOR

CAUTION

In locations where heavy rainfall or severe ice and

snow may occur, Metal Sales' standard gutters may

not be suitable for use.

All Gutter flashings must be installed prior to panel

installation.

1. Install new Box Gutter flashing over top of rigid board

insulation. To hold Box Gutter in place fasten to

substrate with fasteners at 4'-0" oc.

2. Apply a continuous row of Double Bead Tape Sealant

across the Box Gutter flashing.

3. If two or more flashings are required, lap the flashing

over the previously installed flashing by a minimum of

2" placing two rows of Tube Sealant between the

flashings and secure with Pop Rivets, 2.5" oc.

4. Field-bend and place Gutter Straps at 2'-0" oc

(maximum).

5. Install Offset Cleat at Double Bead Tape Sealant

locations and secure with #14-13 Deck Screws at 1'-0" oc.

6. Install the panels by hooking the hemmed edge of the panel (see page 76 for Hemming Instructions) around the

end of the Offset Cleat.

7. Apply Tube Sealant up the side and across the top of the panel ribs before installing the next panel.

BOX GUTTER - FLOATING

:12 Slope

Minimum

INSTALLATION NOTES

Panel Clip w/ (2) #14-13 Deck Screws
Bearing Plate
T-Armor Panel
Tube Sealant (Between Panel Ribs)
#14-13 Deck Screws (1'-0" oc)
Offset Cleat
Tube Sealant (in panel hem)
Double Bead Tape Sealant
Moisture Barrier (by others)

" Pop Rivet (1 per Strap)

Box Gutter
Gutter Strap (2'-0" oc)

9" max

Metal Decking (By others)

*Panel cap not shown for clarity