Metal Sales T-Armor Series - Manual (Page 63)

© Metal Sales Manufacturing Corporation / Subject to change without notice 09/14
63
T-ARMOR
RAKE
INSTALLATION NOTES
Floating Rake Angle and T-Armor panels must be
installed prior to Rake flashing installation (See pages
47-56).
1. Install Roof Cleat on top of rigid insulation. To hold
flashing in place fasten to substrate with fasteners at
4'-0" oc.
2. With T-Armor panel properly nested beside Offset Rake
Slide, apply a row of Double Bead Tape Sealant across
upper side of Offset Rake Slide.
3. Fasten through Offset Rake Slide, Tape Sealant, panel
and into Floating Rake Angle with #12-14 x 1 1 /
4
" Self
Driller XL screws, 1'-0" oc.
4. Apply row of Double Bead Tape Sealant on top of Offset
Rake Slide.
5. Install Rake so that the top of flashing is flush with top of Offset Rake Slide and panel rib. Fasten through
Rake, Tape Sealant and into Offset Rake Slide with ¼"-14 x 7 /
8
" Stitch XL screws, 1'-0" oc.
6. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of
2" placing a bead of Tube Sealant between the flashings and secure with Pop Rivets, 2.5" oc.
Double Bead Tape Sealant
Double Bead Tape Sealant
1 /
4
"-14 x 7 /
8
" Stitch XL (1'-0" oc)
T-Armor Panel
Roof Cleat
Moisture Barrier (by others)
Offset Rake Slide
Floating Rake Angle
#12-14 x 1 1 /
4
" SD XL (1'-0" oc)
#14-13 Deck Screws (1'-0" oc)**
Tek Fasteners (by others)
Steel Angle (by others)
Metal Decking (By others)
OFF MODULE
Rake
CAUTION
**NOTE: DO NOT OVER TIGHTEN.
Fastener must be loose enough to allow for
Rake Angle to move back and forth
ON MODULE
Field close Rake at the Eave
(low end of the flashing run)