Memmert HPP 108/749 Constant climate chamber (Generation 2003) - Manual (Page 53)

53
Advanced functions
If the power supply is interrupted, the time of the power cut and the return of voltage are
stored in the controller.
Reading in the log memory to the computer via USB interface
Using the “Celsius“ progamme, the log memory of the controller can be read out to a com-
puter and from there be displayed graphically, printed out and stored. The log memory of the
controller is not modified or deleted by the reading out.
Printing out log memory
(see also chapter " Printer " on page 41 )
For a printout, the GLP header is also printed automatically, and contains the following details:
► Date of printout
► Period of log
► Consecutive page numbers
► Serial numbers and appliance name
If the printer is not ready (e.g. ink cartridge or paper tray empty), no log data will be lost.
Multiple printouts can also be made, since the log memory is not deleted after printing.
7.6.5 Memory card MEMoryCard XL
On the MEMoryCard XL ( Fig. 32 ), a
temperature control programme with up to 40
ramp segments can be programmed. This can
be programmed directly on the controller or via
the “Celsius“ programme.
To programme the MEMoryCard XL
with the computer and the “Cel-
sius“ software, please read the user
manual for “Celsius“ or the online
help.
For the sake of keeping an overview, it is
recommended that you programme large
programmes graphically on the computer. If a
MEMoryCard XL is programmed, it can only be read in in the same type of chamber for which
it was programmed.
The text field of the MEMoryCard XL can be filled individually with text or diagrams.
Directly programming the MEMoryCard XL via the constant climate chamber
1. Push the MEMoryCard XL into the card reader in the appliance operating panel (see Fig. 2
on page 9 ).
2. Programming the chamber as described in the " Programme mode " Chapter from page
29 . The chosen settings are written directly to the card and stored on it. After the card is
removed, the programme stored internally in the controller is activated again.
Programming the MEMoryCard XL on the computer via the constant climate chamber
1. Connect the computer with an interface cable to the USB interface of the chamber (see
" USB interface " Chapter on page 50 ).
2. Push the MEMoryCard XL into the card reader in the appliance operating panel (see Fig. 2
on page 9 ).
Fig. 32 MEMoryCard XL