3 terminology used, Terminology used, E84aycec communication manual (ethernet powerlink) – Lenze E84AYCEC User Manual
Page 9

EDS84AYCEC EN 3.0 - 09/2012
L
9
E84AYCEC communication manual (Ethernet POWERLINK)
About this documentation
Terminology used
1.3
Terminology used
Term
Meaning
Controller
Lenze controllers of the "Inverter Drives 8400" series
Standard device
»Engineer«
Lenze PC software which supports you in "engineering" (parameterisation,
diagnostics and configuration) throughout the whole life cycle, i.e. from
planning to maintenance of the commissioned machine.
Code
Parameter used for controller parameter setting or monitoring. The term is
usually called "index".
Subcode
If a code contains more than one parameter, these parameters are stored in so-
called "subcodes".
In this documentation a slash "/" is used as a separator between code and
subcode (e.g. "C00118/3").
The term is usually called "subindex".
Lenze setting
This setting is the default factory setting of the device.
Basic setting
HW
Hardware
SW
Software
EPL
Abbreviation for "Ethernet POWERLINK"
(EPL) nodes
Ethernet POWERLINK nodes (Managing Node, Controlled Nodes)
CN
Controlled node (EPL slave)
MN
Managing node (EPL master)
The Managing Node accepts the control function for the data communication of
the decentralised field devices. Typically, the Managing Node is the
communication interface of a PLC.
Node ID
EPL node address