Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 16)

M0217-01 Model 3660
2-4 Rev. 7/11
TM
Machine Operation
Tractor driven PTO pump and oil cooler option is for tractors with less than required hydraulic output needed to
operate hydraulic-driven vacuum fan and other planter hydraulic requirements.
A 1000 RPM PTO is required to operate PTO-driven hydraulic pump.
Option consists of a 1⅜"-21 or 1¾"-20 spline,13.5 GPM 2000 PSI tractor mounted pump, 10 gallon capacity hydraulic
reservoir, 15 GPM-rated oil cooler, spin-on 10-micron oil filter, and required hydraulic valves and fittings.
Vacuum fan assembly
Oil cooler
TRACTOR MOUNTED PTO PUMP AND OIL COOLER OPTION
Flow control valve
Reservoir
Tractor mounted PTO pump
(1⅜" spline PTO pump shown)
Hydraulic reservoir assembly
Oil filter
Hydraulic
motor
NOTICE
Clean and grease PTO shaft coupling with high-pressure
industrial coupling grease (Chevron coupling grease
or equivilant) meeting AGMA CG-1 and CG-2 Standards
each time driveshaft is installed or premature wear and
equipment failure can occur.
Chevron ® trademark is owned by Chevron Products Company.
AGMA is the acronym for American Gear Manufacturers
Association.