Kinze 3660 Lift and Rotate Planter Rev. 7/14 User Manual

Page 115

Model 3660

M0217-01

Rev. 7/11

5-35

Lubrication and Maintenance

4. Measure 67" from left side of inner hitch along

lower frame member of center frame; place

reference mark with an appropriate marker.

Repeat on right side.

5. Measure width of inner hitch, divide value by 2,

measure from one side of hitch, and place a

centerline reference mark at that point on upper

hitch cross member.

6. Measure from centerline to each of the reference

marks on center frame (Y"). If measurements are

NOT equal go to next step. If measurements are

equal skip to Step 8.

7. Rotate center post or push on end of planter

frame with shorter distance. Re-measure from

centerline to reference marks. Repeat until

measurements are equal.

67''

Y''

Field stabilizer

INSTALL ROTATION STOP bLOCK

1. Raise planter to transport position and install

safety lockup.

2. Measure distance between stop mount on inner

hitch and stop surface on center post. Include stop

tap block to determine required combination of

shims to completely fill this space. Tolerance for

filling the space is +1∕16"/-0".

8. Tighten field stabilizer fasteners when

measurements are equal on both sides of

planter.

Stop block measurement