INFICON BPG402-SE ATM to Ultra-High Vacuum Gauge (EtherCAT) - Manual (Page 17)

tira93e1 (2014-04) BPG402-SE.cp
17
Override Enable
0
1 Disable
Enable
Override High Trip
0
1 Disable
Enable
Override Low Trip
0
1 Disable
Enable
High Trip Point Limit: High limit to trigger trip point condition if Input Value (I
0x900E, SI 0x01) is above this limit.
Object index of High Trip Point Value source. Index of High Trip Point Limit (I
0x800E, SI 0x11)
Bit 16…31: Index
Bit 08…15: Subindex
Bit 00…07: reserved
It is only possible to reference to "High Trip Point Limit" (I 0x800E, SI 0x11).
Percentage of Value referenced by High Trip Source Index in [%]. If High Trip
Source Index is I 0x800E, SI 0x11 this parameter is not used.
Low Trip Point Limit: Low limit to trigger trip point condition if Input Value (I 0x900E,
SI 0x01) is below this limit.
Object index of Low Trip Point Value source. Index of Low Trip Point Limit (I
0x800E, SI 0x14)
Bit 16…31: Index
Bit 08…15: Subindex
Bit 00…07: reserved
It is only possible to reference to "Low Trip Point Limit" (I 0x800E, SI 0x14).
Percentage of Value referenced by Low Trip Source Index in [%]. If Low Trip
Source Index is I 0x800E, SI 0x14 this parameter is not used.
High Trip Hysteresis: Hysteresis value for High Trip Point.
Low Trip Hysteresis: Hysteresis value for Low Trip Point.
Object index of active source of (I 0x900E SI 0x01) Input Value.
Source Index
Bit 16…31
Bit 08…15
Bit 00…07
Index
Subindex
Reserved
Subindex 0x04
Subindex 0x05
Subindex 0x06
Subindex 0x11
Subindex 0x12
Subindex 0x13
Subindex 0x14
Subindex 0x15
Subindex 0x16
Subindex 0x17
Subindex 0x18
Subindex 0x1A