INFICON Explorer Portable Gas Chromatograph - Manual (Page 86)

Explorer Operator Manual
84
5. Press Enter Menu to re-open the menu and press LOG.
The display will show the most recent Log entry. If the last analysis is
complete, it will be the same as the real time display. The display remains the
same as the selected display. If you are in peak display, the logged data will be
shown in peak display.
6. Press VIEW to review the datalogger entries.
7. Press NEXT or PREV to move through the entries.
The status line shows the log entry number and the date and time the sample
was taken. Alternately, the column and the run number will be shown on the
status line. The two lines of information will alternate.
NOTE: If you are reviewing GC data, you can change the display by pressing DISPLAY and
selecting the desired display option. If you are reviewing TVOC data then you can
choose to display REPORT or GRAPH format.
8. Press Exit to return to the real time display.
Deleting Datalogger Entries
When the datalogger becomes full you must delete the contents. You can delete
selected datalogger entries using the delete option.
NOTE: You can connect Explorer to a PC and use the SiteChart software to store the logged
data, as detailed on page 128. It is strongly recommend that SiteChart is used to
download data from Explorer. The datalogger entries are saved in a folder
created on your PC and then deleted from the datalogger.
Deleting a single entry
1. Press Enter Menu, then LOG and VIEW.
2. Press NEXT or PREV to move through the entries and select the log entry to be
deleted.
Press Exit to go back one level on the menu tree.